When you see a beautiful home, you assume that the interiors look just as good. But more often, you’d be surprised by what’s on the inside. Over time, expensive walls with fabulous paint jobs end up looking quite the opposite.
So, why does this happen?
Is it because of using cheap materials or due to the lack of procedure followed during the painting? Dampness or Flaking?
Odds are that it is a mix of all these, but the biggest culprit eating away at your walls is the moisture. Once it gets into your walls, it causes peeling, flaking, and leaves your walls in a powdery situation.
How does it begin?
What often leads to the accumulation or seeping of moisture in the walls is the cement itself. When not appropriately treated during the initial stages of construction. Minute cracks in the cement are as good as open invitations to trouble.
Eventually, the accumulation of dampness in the walls leads to the formation of new cracks and the widening of the existing ones, and it is not just the paints that it harms. The dampness also houses the growth of bacteria and fungi, exposing your home to a health hazard.
What if it is already done?
It is not all bad news, there are quite a few ways to prevent the cracks from causing problems, both during and after construction. The simplest way to protect your walls is with a coat of putty. It adds an active layer of protection to the surface. The insulation provides not only prevents damage from moisture but also excessive heat.
It is recommended that the putty is applied before the painting process in the early stages of construction.
If your walls have started showing signs of damage and dampness, then a quick renovation can also solve this problem. It will mean a lot of work and re-painting, but the results are always worth the effort.
Are you looking for some recommendations and tips?
It goes without saying that if your walls are protected, your paints will also be. But what if you could kill two birds with one stone? For example, instead of using regular wall putty, you can go for a white cement based putty. The difference is both visual and integral.
A white cement-based putty gives your walls a layer of, quite literally, whiteness. This allows you to skip the whitewashing process before you begin painting as your walls already look pristine and pure. Apart from being a good base for the paints, the cement-based properties help with moisture and heat insulation. If you are looking for an excellent white-cement based putty, we recommend Birla White Wall Care Putty.
A double layer of protection that effectively keeps damage causes moisture at bay, guaranteeing to keep your walls and surfaces looking beautiful through the years.
No more worry about flaking, peeling paints, dampness, or cracks.